* MAXPlus2/Quartus( ALTERA) ISE (Xilinx) programmable logic development system.
* ModelSim Simulation - RTL and GateLevel.
* ORCAD Capture for windows and DOS tools.
* Concept ® HDL Schematic from Cadence.
* Allegro PCB Layout and SPECCTRA AutoRoute Tools.(inhouse)
* POLAR stack PCB design for control impedances.
* High Speed Design over FR4 and Rogers.
* Cadence SpecctraQuest HighSpeed , sigNoise , Signal integrity Simulation.
* Engineering.
* Solutions for EOL/obsolete components.
* Design transfer to RoHS.
* C Programming.
* AutoCad (mechanical) tools.
The board designed and Produced by Elik-tronics for Applied Materials
Consists of 12 FPGAs and 4 CPLDs.
It is used to process an Image from a Line Scan Camere.
The board consists FPGA CyclonII EP2C35 (migrated to C50) Designed by Elik-tronics, 2 fast analog channels sampled in 220Mhz ADCs and enter ( 12 bits LVDS) to the CycloneII
The CycloneII processes the data, use arithmetics and use true dual port rams
many modes of oparations (data ordering etc.) are used- including diagnostic mode
(injects pattern generator data to the input)
We achieve work frequency of 240Mhz !!! in CycloneII .
The output is full Camera link 5.5Gbps.
The board on the left designed produced by Elik-tronics for broadband fixed wireless
access system. the board consists ATM Layer (S/UNI ALTLASPMC Sierra) and S/UNI VERTEX
chip set from PMC Sierra - the processor is POWERQUICC MPC8260 (Motorola)
The Card provides ATM traffic policing (S/UNI-ATLAS),
ATM cell traffic management (S/UNI-APEX) and ATM cell multiplexing.
The CEM communicates the with the more line cards
(design by Elik-tronics,as well) via the serial LVDS
lines using the PMC protocol .(S/UNI-VORTEX and S/UNI-DUPLEX).
On the network side,the Card interfaces via 2 optical transceivers-2x STM1/OC3c interfaces.
The board on the left designed by Elik-tronics ALLOT Communicaion
the board consists 2x10Gb XFP Interfaces , 2 x SerDeses (Vitesse) interfaces with 2x MACs
(Vitesse) with XAUI protocol .
The MACs output is 2x SPI4.2 ineterfaces to connecors
Elik-tronics , designed the CPLD (MaxII) , as well - that control all the peripherals
The board designed produced by Elik-tronics for cPCI wide cage
the board consists Xilinx Vertex-5 (110T), 12 Channels optical links (Rx and Tx for testing)
600 Mhz DDR2 interface (with SODIM) , 4 full camera link fast interfaces.
The Virtex-5 uses 12 internal GTPs - and performs about 36 Gbps !
optical trancievers are Zarlink ( cross-ref with Agilent and Picolight )
all the fast serial links have been tested for zero BER.
BACK TO HOME PAGE